Steam-thawed, not chipped. We stop the leak and the damage.
Roof Ice Dam Removal union city NJ done right the first time
Roof Ice Dam Removal union city NJ is what we do when winter backs water up under your shingles and into your ceiling. We send a licensed crew with steamers and infrared cameras, not ice picks and hammers. If you have a stain spreading across a bedroom ceiling or water running down a wall on Bergenline Avenue, call (201) 555-0147 and we will be there the same day.
What Roof Ice Dam Removal union city NJ actually involves
Roof ice dam removal union city NJ is the process of safely clearing the ridge of ice that forms along your eaves, then restoring drainage so meltwater leaves the roof instead of backing up under the shingles. We do it with low-pressure steam, not chisels. A 200-degree steamer melts channels through the dam in 30 to 90 minutes per section, and an infrared thermal camera confirms where the water is actually sitting before we touch anything.
Union City gets hit hard because most of our housing stock is 80 to 120 years old, with shallow roof pitches, minimal insulation, and gutters that were sized for a smaller storm. When a nor'easter dumps 8 inches of snow and the temperature swings from 28 to 40 degrees overnight, that snow melts, refreezes at the eave, and the next melt has nowhere to go but into your house. If you search roof ice dam removal near me union city after a storm, that is exactly the call we take.
Every job includes the same core scope, priced flat before we start. If your roof needs something outside that scope, we tell you before we touch it and you decide. No surprise line items on the invoice.
01
✓
Full roof inspection
We walk the entire roof with an extension ladder and safety harness, scan the attic with an infrared thermal camera, and check the moisture meter readings at every stain. You get a written scope with photos before any work begins.
02
✓
Steam removal of all dams
We steam every ice dam on the roof, not just the one causing the leak. A dam you cannot see yet is a dam that will call us back in two weeks. Typical residential roofs take 2 to 4 hours of steaming time.
03
✓
Flashing and boot inspection
Once the ice is off, we inspect the flashing, valleys, pipe boots, and ice and water shield for damage the freeze caused. Anything loose gets reset with new sealant. Anything cracked gets replaced with matching material.
04
✓
Gutter and downspout clearing
We clear the ice and debris out of the gutters and downspouts so meltwater has somewhere to go. A clogged gutter is what built the dam in the first place, and leaving it clogged guarantees a repeat next storm.
05
✓
Attic heat-loss report
We map the warm spots in your attic and give you a one-page report showing where the heat loss is and what it would take to fix it. This is the difference between removing the dam and preventing the next one.
06
✓
Water test before we leave
We run a hose over the repaired area and watch it drain. If water still backs up or finds a path into the house, we stay on the roof until it does not. You do not pay until the leak is actually stopped.
How it works
How our roof ice dam removal service works
You call (201) 555-0147 and describe what you are seeing: a ceiling stain, water running down a wall, ice on the gutter, or a bulge in the soffit. We ask three or four questions to size the job, quote a flat range on the spot, and schedule a same-day or next-morning visit. No dispatch fee, no diagnostic charge.
A technician walks the roof with an extension ladder and safety harness, then scans the attic with an infrared thermal camera and a moisture meter. We find the dam, the entry point, and any secondary leak the dam has been hiding. You get a written scope before we start, and the price does not change mid-job.
We set up a low-pressure steamer and melt channels through the ice from the eave upward, working in 6- to 10-foot sections. A typical 1,500-square-foot roof takes 2 to 4 hours. We never use a pry bar, an axe, or a roofing nail gun on ice. The shingles underneath come out untouched.
Once the ice is gone, we inspect the flashing, pipe boots, valleys, and ice and water shield. If the dam pulled anything loose, we reset it with roof cement and new sealant, and replace any damaged shingles with matching material. We test with a hose before we leave the roof.
Before we pack up, we give you a one-page report: where the heat loss is, how much insulation you need, and what gutter work will keep the next storm from rebuilding the dam. Most customers spend $400 to $1,200 on prevention and skip the emergency call the following winter.
STEP 01Phone triage
You call (201) 555-0147 and describe what you are seeing: a ceiling stain, water running down a wall, ice on the gutter, or a bulge in the soffit. We ask three or four questions to size the job, quote a flat range on the spot, and schedule a same-day or next-morning visit. No dispatch fee, no diagnostic charge.
Tools & methods
Tools and methods we use on every job
01
✓
Low-pressure steam unit
Melts ice dams from the top down without touching the shingle surface. Runs at 200 degrees and clears a 6- to 10-foot section in about 20 minutes. This is the only method we use on shingles, slate, and tile.
02
✓
Infrared thermal camera
Finds both the leak and the heat loss feeding the dam. We scan the attic and roof deck, mark the warm spots, and use that map to plan the insulation work that stops the next dam.
03
✓
Moisture meter
Confirms exactly where water has reached inside the ceiling, walls, and insulation. It tells us whether a stain is fresh or old, which changes how urgent the repair is.
04
✓
Roof inspection drone
Lets us survey steep or fragile roofs safely before we send a technician up. We use it on slate and tile roofs where foot traffic is a risk, and on tall multi-family buildings.
05
✓
Extension ladder and safety harness
Standard access equipment for every job. Every technician is OSHA Safety Certification trained and clipped in before stepping onto the roof, regardless of pitch or height.
06
✓
Pitch hoist
Moves heavy material up steep roofs without damaging shingles or risking a fall. We use it when a repair requires new underlayment, flashing, or a full section of shingles.
Real results
Before and after.
Roof Ice Dam Removal
Bergenline Avenue two-family, active leak
A two-family on Bergenline Avenue had a 4-inch ice dam along the entire south eave and water dripping through a second-floor bedroom ceiling. The owner had been catching it in a bucket for two days and the stain had grown to about 3 feet across.
After: We steamed the dam out in 90 minutes, traced the entry point to a lifted shingle tab and a failed pipe boot, and repaired both the same visit. The leak stopped before we left the roof. Total job time was just under 4 hours.
A landlord on 48th Street had the same ice dam on the same eave three winters in a row. A previous contractor had chipped the ice off twice, which cracked six shingles and left a slow leak that showed up every time it rained.
After: We steamed the dam, replaced the six cracked shingles with matching GAF material, and reset the ice and water shield where the chipping had torn it. We also cleared the clogged gutter that was feeding the dam. The leak stopped and the roof is warrantable again.
A slate roof in Union City Heights had a thick dam along the north slope that had been there for three weeks. Two other contractors refused the job because chipping would have cracked the slate. Water was starting to show at the soffit.
After: We steamed the dam in 3 hours, working carefully around the slate edges. We found two cracked slates from an earlier repair and reset them with copper flashing and slate hooks. The soffit dried out within a week and the leak stopped.
We prioritize active leaks for same-day service. A technician steams a drainage channel through the dam, stops the water at the source, and repairs the entry point in the same visit. Most active leaks stop within 90 minutes of our arrival.
↗02
Ice dam on a low-slope roof with no attic access
We steam the dam from the roof surface and use an infrared thermal camera from outside to map the warm spots. For EPDM, TPO, and modified bitumen roofs, we repair the membrane with matching Carlisle SynTec or Firestone Building Products material.
↗03
Clogged gutter feeding a recurring dam
We clear the gutter and downspout completely, reseal the seams, and check the hangers. If the gutter is undersized for the roof area, we tell you and quote a replacement before the next storm instead of after.
↗04
Damaged shingles from a previous chipping job
We inspect the whole roof after steaming and replace any shingles the previous work damaged. We match GAF, Owens Corning, or CertainTeed material to your existing roof so the repair blends and the warranty stays intact.
↗
Proof you can check
Licensed, insured, and accountable
NJ Home Improvement Contractor (HIC) License · New Jersey Division of Consumer Affairs
NJ Roofing Contractor License · New Jersey Division of Consumer Affairs
OSHA Safety Certification · Occupational Safety and Health Administration
EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
NRCA Member · National Roofing Contractors Association
Customer reviews
What Union City customers say
★★★★★
“Water was coming through my kitchen ceiling at 9 p.m. on a Sunday. They answered the phone, told me what to do until they arrived, and had a guy on the roof by 11. The steam melted a channel through the ice in about an hour and the dripping stopped. They came back Tuesday to check the flashing. Fair price, no drama.”
MG
Maria G.Homeowner, Bergenline Avenue
✓ Verified
“
★★★★★
“I manage three multi-family buildings and every winter I get the same ice dam calls. Union City Roof Rescue handled all three in one day, sent me photos of every section they steamed, and gave me a heat-loss report I could act on. Two of the three buildings have not had a dam since. That is worth the money.”
AR
Anthony R.Landlord, 48th Street
✓ Verified
★★★★★
“A previous contractor chipped the ice off my roof and cracked four shingles. These guys steamed it and did not touch a single shingle. They also found a pipe boot that was about to fail and replaced it in the same visit. Honest work, and they explained everything without trying to upsell me.”
Most residential jobs in Union City run $350 to $900 in 2026, with a typical single-family home landing around $550. Price depends on roof size, ice depth, pitch, and how many sections need steaming. Commercial flat roofs and large multi-family buildings run higher. We quote a flat range on the phone and confirm it on-site before any work starts.
We use low-pressure steam, not chisels or hammers. A technician sets up a steamer on the roof, melts channels through the ice from the eave upward in 6- to 10-foot sections, and confirms the drainage path with an infrared thermal camera. A typical roof takes 2 to 4 hours. The shingles underneath are never touched, so there is no granule loss and no warranty issue.
Union City Roof Rescue does, and we cover every neighborhood from Bergenline Avenue to the North Bergen border. Call (201) 555-0147 and we will schedule a same-day visit for active leaks or a next-morning slot for non-emergency work. We are licensed, insured, and we carry steamers on the truck all winter, so we are not scrambling for equipment when you call.
Yes, if the dam is removed before it forces water under the shingles. Once we steam the ice out and restore drainage, the backup stops and so does the leak. The permanent fix is attic air sealing and insulation, which keeps the roof deck cold. We include a heat-loss report with every job so you can stop the next dam before it forms.
We answer the phone seven days a week, including holidays, and we run same-day emergency calls for active leaks. Licensed, insured, and steam-only. Call (201) 555-0147 and we will tell you exactly what it takes to stop the water.
Call us at (201) 555-0147 or email info@unioncityroofrescue.com. We answer the phone 24/7 for active leaks and schedule standard inspections Monday through Friday. If you leave a message after hours, we call back within the hour.