Licensed BUR roof leak repair union city NJ crews, same-day

Built-Up Roof Leak Repair in union city that stops the water

Built-Up Roof Leak Repair in union city means finding the seam, blister or flashing failure that is letting Hudson County rain into your building and sealing it for good. We handle BUR roof leak repair union city NJ for three-story walk-ups, Bergenline Avenue storefronts and Troy Towers-area buildings. Call and we roll a truck today.

Professional Built-Up Roof Leak Repair in union city
Careful work. Honest options.
About this service

What Built-Up Roof Leak Repair in union city involves

Built-Up Roof Leak Repair in union city is the trade of locating and sealing failures in a multi-ply asphalt and felt roof system, then restoring the plies so the assembly keeps shedding water. A BUR roof is layers of built-up roofing felt mopped with hot asphalt, finished with gravel or a cap sheet. When a seam opens, a blister splits or roof cement dries out, water tracks sideways under the plies and shows up ten feet from the actual hole. We cut the repair open, dry it, and rebuild it ply by ply.

Union City's housing stock makes this the most common flat-roof call we run. Rows of 1920s to 1950s walk-ups along Summit Avenue and Palisade Avenue have BUR roofs that have been patched a dozen times, and ponding water sits on them after every storm because the drains and gutters clog with leaves. If you searched built-up roof leak repair near me union city after a ceiling stain appeared, the leak is usually at a flashing, a pipe boot or a low spot that never drains.

  • ✓ Same-day leak triage
  • ✓ We find the real source
  • ✓ Repairs built to last
  • ✓ Written warranty on the work
What's included

What our Built-Up Roof Leak Repair includes

Every BUR repair we do covers the diagnostic work, the repair itself and the cleanup. Here is what is standard on the job, and what we quote separately if your roof needs it.

01
✓

Full leak diagnosis

Moisture meter readings across the roof field, infrared thermal camera scan on larger roofs, and a visual check of every seam, flashing, pipe boot and drain. We confirm the source before we cut anything open, so the repair stays small.

02
✓

Ply-by-ply rebuild

We cut the failed area back to dry material, then rebuild the layers with built-up roofing felt and modified bitumen. The repair matches the original ply structure, so it moves with the roof instead of cracking off it.

03
✓

Flashing and boot re-seal

Wall flashing, base flashing, counterflashing and pipe boots get re-sealed or replaced as part of the repair. These are the most common leak points on a BUR roof, so we do not leave them for a second visit.

04
✓

Drain and gutter clearing

A BUR roof that ponds will leak again no matter how good the repair is. We clear the drains, gutters and downspouts so water leaves the roof. This is included on every repair, not sold as an add-on.

05
✓

Water test and photos

We flood-test the repair area and watch it for 20 minutes before we leave. You get photos of the finished work and your written warranty paperwork the same day, so you have a record for your building file.

How it works

How our BUR leak repair process runs

You call and describe the stain, the drip or the smell. We ask where it is, how long it has been there and whether the roof is flat or pitched. That tells us whether to send a tarp crew first or a diagnostic crew. Most Union City calls get a same-day window.

On site we walk the roof with a moisture meter and, on larger buildings, fly a roof inspection drone over the field. We check seams, flashing, pipe boots, drains and the parapet walls. Inside, we read the ceiling and joists to confirm how far the water has traveled. This takes 45 to 90 minutes.

We tell you what failed, why it failed and what the fix costs before we start. You get the price up front, not a surprise invoice. If the roof is past patching, we say so and quote a replacement instead of selling you a patch that fails in six months.

We cut back the failed area to sound material, dry it, and rebuild the plies. Most BUR repairs take two to five hours. We re-seal flashing, reset pipe boots and clear the drains so water leaves the roof instead of sitting on it.

Before we leave we flood-test the repair area and watch it for 20 minutes. Then we haul off every scrap of old felt and asphalt and sweep the roof. You get photos of the finished work and your warranty paperwork the same day.

Built-Up Roof Leak Repair
STEP 01Phone triage

You call and describe the stain, the drip or the smell. We ask where it is, how long it has been there and whether the roof is flat or pitched. That tells us whether to send a tarp crew first or a diagnostic crew. Most Union City calls get a same-day window.

Tools & methods

Tools and methods we use on BUR roofs

01
✓

Moisture meter

Reads moisture content in the roof plies and insulation. It tells us how far water has spread from the visible failure, so we cut back to dry material instead of guessing.

02
✓

Infrared thermal camera

Reads temperature differences on the roof surface to reveal saturated insulation and wet plies under a BUR system. Fastest way to map a leak without cutting the roof open.

03
✓

Roof inspection drone

Flies over larger BUR roofs to check seams, flashing and drains from above. Useful on tall Union City buildings where a full walk is slow and risky.

04
✓

Pitch hoist

Lifts bundles of felt, modified bitumen and tools onto the roof without carrying them up a ladder. Keeps the crew off ladders with heavy loads and speeds up the job.

05
✓

Roofing nail gun and caulking gun

Fastens base sheets and applies sealant at flashing terminations and penetrations. We use them where the repair calls for mechanical fastening instead of hot asphalt.

06
✓

Pry bar and utility knife

Cuts and lifts the failed plies so we can inspect what is underneath. Clean cuts mean the new plies bond properly to the old roof.

Real results

Before and after.

Bergenline Avenue storefront ceiling leak
Built-Up Roof Leak Repair

Bergenline Avenue storefront ceiling leak

Water was dripping onto the sales floor every time it rained hard. Two previous patches had failed, and the ceiling tile above the register was stained and sagging. The roof had a split seam near the parapet and a drain clogged with leaves that was causing the whole field to pond.

After: We rebuilt the split seam ply by ply, re-flashed the parapet and cleared the drain. The store stayed open during the work. Four hours on the roof, and the ceiling has stayed dry through two storm seasons since. The owner replaced the stained tile himself.

Book this service →
Summit Avenue walk-up pipe boot failure
Built-Up Roof Leak Repair

Summit Avenue walk-up pipe boot failure

A top-floor tenant had a ceiling stain that kept growing after every rain. The stain was six feet from the actual leak. A failed pipe boot on the BUR roof was letting water in, and it was traveling under the plies before showing up inside.

After: We replaced the pipe boot, re-flashed the penetration and rebuilt the surrounding plies. The repair took under two hours. The stain stopped growing immediately, and the landlord was able to repaint the ceiling two weeks later once it dried out.

Book this service →
32nd Street commercial BUR field repair
Built-Up Roof Leak Repair

32nd Street commercial BUR field repair

A commercial building had multiple leaks across a large BUR field. The roof had been patched repeatedly over the years, and the property manager was ready to replace the whole roof. We ran an infrared thermal camera scan to see how far the saturation had actually spread.

After: The scan showed the saturation was limited to two areas, not the whole field. We repaired both areas, rebuilt the flashing and cleared the drains. The repair cost a fraction of a replacement, and the roof has been dry since. The manager now has a documented condition report for future budgeting.

Book this service →
Problems we solve

BUR roof leak problems we solve in union city

Most of the BUR calls we get in Union City fall into a handful of patterns. Here are the ones we see most, and what happens if you leave them alone.

Ask a pro →
01

Ceiling water stain that keeps coming back

We trace the water back to the actual failure with a moisture meter and infrared thermal camera, then repair the seam or flashing at the source. The stain stops growing because the water stops getting in.

↗
02

Ponding water on a flat BUR roof

We clear the drains, gutters and downspouts, then check the roof slope to find low spots. If the ponding is caused by a failed drain or a sagging deck, we repair that as part of the job so the water actually leaves.

↗
03

Pipe boot failure on a BUR roof

We replace the boot and re-flash the penetration with compatible materials. The repair is small, usually under two hours, and it stops the leak that has been showing up as a ceiling stain ten feet away.

↗
04

Flashing leak at a parapet or wall

We rebuild the flashing, replace failed sealant and re-set the counterflashing. This is the repair that stops the leak that keeps coming back no matter how many times someone patches the roof field.

↗
Proof you can check

Licensed, insured and accountable

  • NJ Home Improvement Contractor (HIC) License · New Jersey Division of Consumer Affairs
  • OSHA Safety Certification · Occupational Safety and Health Administration
  • EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
  • GAF Master Elite · GAF
  • NRCA Member · National Roofing Contractors Association
Customer reviews

What Union City customers say

★★★★★
“We had a ceiling stain in the top-floor apartment that kept coming back after every rain. Two other guys smeared cement on the roof and it still leaked. Union City Roof Rescue brought out a moisture meter and found the real problem was a failed pipe boot three feet from where the stain was. They rebuilt the plies around it and we have been dry through two winters now.”
MG

Maria G.Building Owner, Bergenline Avenue

✓ Verified
★★★★★
“Water was coming through the ceiling of my shop every time it rained hard. They found a split seam near the parapet and a clogged drain that was making the whole roof pond. Fixed both in one visit, about four hours. They showed me photos of the finished repair and gave me a written warranty. No drama, no upsell.”
AP

Anthony P.Storefront Owner, 32nd Street

✓ Verified
Good questions

Frequently Asked Questions

(551) 348-9609

Most BUR leak repairs in union city NJ run $350 to $1,200 in 2026, depending on how much roof has to be opened and whether flashing or a pipe boot is involved. A small seam repair starts around $350. A larger repair that includes parapet flashing, a new pipe boot and drain clearing lands closer to $1,200. Emergency tarp-and-secure calls start at $250 and get credited toward the permanent repair.

We find the failure with a moisture meter and infrared thermal camera, cut the plies back to dry material, then rebuild the layers with built-up roofing felt and modified bitumen. Flashing, pipe boots and drains get reset or replaced at the same time. Most repairs take two to five hours, and we flood-test the area before we leave. The point is to restore the ply structure, not cover the seam.

Yes, if the surrounding plies are still sound. A patch works when the leak is a single seam, a cracked flashing or a failed pipe boot. It does not work when the whole field is saturated or the plies are brittle across the roof. We tell you which one you have after the inspection. If a patch is the right call, we patch. If it is not, we say so.

Union City Roof Rescue handles BUR roof leak repair union city NJ 07087 and the surrounding Hudson County blocks, including Downtown Union City, Summit Avenue, Palisade Avenue and the North Bergen Border. Call (551) 348-9609 and we will get a crew out, usually the same day. We carry the NJ Home Improvement Contractor (HIC) License and OSHA Safety Certification on every job.

Ready when you are

Get Built-Up Roof Leak Repair in union city today

Water is already inside your building. Every hour it sits, the damage spreads into the deck, the insulation and the ceiling below. Call (551) 348-9609 and we will get a licensed crew on your roof, usually the same day. Upfront price before we start. Written warranty when we finish.

Call Now (551) 348-9609 →
Request an appointment

Call Union City Roof Rescue

Call us at (551) 348-9609 or email info@unioncityroofrescue.com. We answer the phone 24/7 for active leaks and schedule standard inspections Monday through Friday. If you leave a message after hours, we call back within the hour.

↗
Emergency?Call now