Chimney, skylight, valley, and pipe boot flashing fixed right the first time

Roof flashing repair union city NJ that stops the leak for good

When water shows up on your ceiling, the culprit is usually the flashing, not the shingles. Our roof flashing repair union city NJ crews find the exact breach, seal it with the right materials, and test it before we leave. We handle flashing leak repair union city NJ for flat roofs, shingle roofs, and everything between, from Bergenline Avenue to the Troy Towers Area.

Professional Roof Flashing Repair in union city
Careful work. Honest options.
About this service

Roof flashing repair union city NJ done by roofers who do it daily

Roof flashing repair union city NJ is the work of resealing, rebuilding, or replacing the metal and membrane pieces that keep water out of the joints on your roof. Flashing sits at every penetration and transition: chimney walls, skylight curbs, vent pipes, valleys, headwalls, and the edges where the roof meets a parapet. When that metal lifts, corrodes, or loses its sealant, water walks straight into your attic. We repair it, not patch it.

Union City roofs take a beating. Hudson County winters throw freeze-thaw cycles at every seam, and summer storms push water sideways against chimney flashing that was already tired. In the dense blocks around Summit Avenue and Palisade Avenue, we see the same pattern over and over: a small flashing leak that started as a ceiling stain becomes a rotted roof deck after one wet season. That is why we treat every flashing leak fixing company union city NJ call as urgent, not routine.

  • ✓ Stop the leak today
  • ✓ Save the deck, not just the shingles
  • ✓ Work that survives the next winter
  • ✓ Flat roof and shingle roof experience
What's included

What our flashing repair service includes

Every flashing repair starts with a full inspection and ends with a water test. Here is what is covered. If we find something outside the flashing repair, we tell you before we do anything, and you decide whether to add it.

01
✓

Full roof flashing inspection

We inspect chimney, skylight, pipe boot, valley, headwall, and edge flashing. We use a moisture meter and infrared thermal camera to confirm where the water is entering, not just where it is showing up inside.

02
✓

Leak source confirmation

We trace the leak to its actual source and show you photos. This step is what separates a real flashing repair from a guess. You see the failed material before we remove it.

03
✓

Flashing removal and replacement

We remove the failed flashing with a pry bar and utility knife, then install new flashing with ice and water shield underneath. We use GAF, Owens Corning, or CertainTeed materials matched to your roof type.

04
✓

Sealing and waterproofing

New flashing gets sealed with roof cement and a sealant rated for Hudson County freeze-thaw cycles. We do not use cheap caulk that cracks in one season. The seal is built to last.

05
✓

Water test and final check

Before we leave, we water-test the repair and re-check the moisture meter. You get photos of the finished work and a written warranty on the flashing repair. If it leaks in the covered period, we come back.

How it works

How our flashing repair process works

You call (551) 348-9609 or book online. We ask what you are seeing: ceiling stain, dripping in the attic, water at the chimney. Most Union City jobs get a same-day or next-day visit. If it is an active leak, we treat it as emergency roof flashing leak repair union city NJ and get out faster.

We get on the roof with an extension ladder and safety harness, then work the suspect area with a moisture meter and infrared thermal camera. We check the chimney, skylight, pipe boots, valleys, and headwall flashing. You get a straight answer about where the water is actually coming in, not a guess.

We photograph the failed flashing and walk you through it. Lifted step flashing, cracked sealant, rusted valley metal, a torn pipe boot. You see what we see before we touch anything. Then we give you one clear price for the repair.

We remove the failed material with a pry bar and utility knife, install new flashing, and seal it with roof cement and the right membrane. Most flashing repairs take two to four hours. We use roofing nail guns and caulking guns, and we keep the work area clean the whole time.

Before we leave, we water-test the repair and re-check the moisture meter reading. You get photos of the finished work and a written warranty on the flashing. If anything leaks in the covered period, we come back. That is the whole deal.

Roof Flashing Repair
STEP 01Call and schedule

You call (551) 348-9609 or book online. We ask what you are seeing: ceiling stain, dripping in the attic, water at the chimney. Most Union City jobs get a same-day or next-day visit. If it is an active leak, we treat it as emergency roof flashing leak repair union city NJ and get out faster.

Tools & methods

Tools and methods we use for flashing repair

01
✓

Moisture meter

Confirms where water is trapped in the roof assembly. We use it before and after the repair to prove the leak is fixed.

02
✓

Infrared thermal camera

Reveals hidden moisture under the roof surface by reading temperature differences. Essential for flat roof flashing leaks that are not visible from the top.

03
✓

Roof inspection drone

Lets us inspect steep or hard-to-reach roof sections safely. We use it to document flashing condition before and after the repair.

04
✓

Extension ladder and safety harness

Standard access and fall protection for every roof we work on. Our crews are OSHA Safety Certified and harness up on every job.

05
✓

Pry bar and utility knife

Used to carefully remove failed flashing and sealant without damaging the surrounding shingles or membrane.

06
✓

Roofing nail gun and caulking gun

For fastening new flashing and applying sealant evenly. The right tool for the material keeps the repair clean and durable.

Real results

Before and after.

Chimney flashing rebuild on Bergenline Avenue
Roof Flashing Repair

Chimney flashing rebuild on Bergenline Avenue

A homeowner had a ceiling stain that kept growing after every rain. Two roofers told them the roof was shot and quoted a full replacement. We inspected and found the chimney step flashing had pulled away from the brick, with water running behind it into the attic.

After: We rebuilt the step flashing and counter-flashing, installed new ice and water shield, and sealed the joint. The repair took four hours and cost $720. The leak stopped, and the ceiling stain dried out within a week. No roof replacement needed.

Book this service →
Flat roof parapet flashing repair near Troy Towers
Roof Flashing Repair

Flat roof parapet flashing repair near Troy Towers

A property owner had water coming into a top-floor unit after storms. The leak was nowhere near the visible damage on the membrane. We used an infrared thermal camera and found the wall flashing had separated at the parapet, letting water pond under the membrane.

After: We repaired the parapet flashing with heat-welded TPO membrane, resealed the termination, and cleared a partially blocked drain that was making the ponding worse. The repair took half a day. The unit stayed dry through the next three storms.

Book this service →
Pipe boot replacement on Summit Avenue
Roof Flashing Repair

Pipe boot replacement on Summit Avenue

A homeowner called about a drip in the hallway ceiling every time it rained. The roof was only eight years old, so a full replacement made no sense. We got on the roof and found the pipe boot around the plumbing vent had cracked and dried out from UV exposure.

After: We replaced the pipe boot with a new UV-rated boot, resealed the base, and water-tested it. The whole job took under two hours and cost $310. The drip stopped immediately, and we checked the other boots on the roof while we were there.

Book this service →
Problems we solve

Flashing problems we fix in Union City

Most flashing leaks fall into a handful of categories. Here are the ones we see most often on Union City roofs, and what happens if you leave them alone.

Ask a pro →
01

Chimney flashing pulling away from the brick

We rebuild the step flashing and counter-flashing, then seal the joint with a flexible sealant that moves with the brick. Most chimney flashing repairs take three to four hours and stop the leak the same day.

↗
02

Pipe boot cracked or dried out

We replace the pipe boot with a new UV-rated boot sized to your pipe. This is one of the fastest, cheapest flashing repairs we do, usually under two hours. We check every other boot on the roof while we are up there.

↗
03

Skylight curb flashing leaking at the corners

We repair or rebuild the skylight curb flashing with new membrane and sealant, then water-test it. If the skylight itself is also failing, we tell you and give you a separate price for that.

↗
04

Valley metal rusted through

We replace the valley metal and the underlayment beneath it, then weave the new material into the existing shingle courses. This is a bigger repair, but it stops a leak that will never fix itself.

↗
Proof you can check

Licensed, insured, and accountable

  • NJ Home Improvement Contractor (HIC) License · New Jersey Division of Consumer Affairs
  • GAF Master Elite · GAF Materials Corporation
  • Owens Corning Preferred Contractor · Owens Corning
  • EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
  • OSHA Safety Certification · Occupational Safety and Health Administration
Customer reviews

What Union City customers say

★★★★★
“We had a stain on the ceiling for weeks and two other roofers told us we needed a whole new roof. Union City Roof Rescue found the leak at the chimney flashing in about twenty minutes. They repaired it the same day for under $600. No leak since, and that was two winters ago.”
MG

Maria G.Homeowner, Bergenline Avenue

✓ Verified
★★★★★
“Called on a Friday with water dripping into our hallway. They came out the same afternoon, sealed the pipe boot flashing, and stopped it. The technician explained what failed and why. Fair price, clean work, and they cleaned up after themselves. Highly recommend.”
JL

Jennifer L.Homeowner, Summit Avenue

✓ Verified
Good questions

Frequently asked questions about flashing repair

(551) 348-9609

Most flashing repairs in Union City run $250 to $850 in 2026, depending on the type and how much material has to come off. A simple pipe boot reseal is on the low end. Chimney flashing rebuilds and valley metal replacement sit higher. We give you the exact price after we inspect, before any work starts.

We locate the breach with a moisture meter and infrared thermal camera, remove the failed flashing, and rebuild it with new metal, ice and water shield, and sealant. Then we water-test the repair and re-check the reading. Most fixes take two to four hours. If the deck underneath is rotted, we replace that too before closing it up.

We do. Union City Roof Rescue handles flashing repair across Hudson County, from Bergenline Avenue to the West New York Border. Call (551) 348-9609 and we will schedule a visit, usually same-day or next-day. If it is an active leak, tell us and we will prioritize it.

Yes, in most cases. Flashing fails long before the shingles or membrane do, so a targeted repair is usually all you need. We only recommend a full replacement when the deck is rotted through or the roof is already past its service life. We will tell you honestly which one you are looking at.

Ready when you are

Get your roof flashing repair union city NJ scheduled today

If water is coming in, every day you wait makes the repair bigger. Call (551) 348-9609 and we will get on the roof, find the leak, and fix the flashing. Same-day and emergency service available across Union City and Hudson County.

Book a repair (551) 348-9609 →
Request an appointment

Call Union City Roof Rescue

Call us at (551) 348-9609 or email info@unioncityroofrescue.com. We answer the phone 24/7 for active leaks and schedule standard inspections Monday through Friday. If you leave a message after hours, we call back within the hour.

↗
Emergency?Call now