Fast, code-correct fixes for every metal roof leak

Metal Roof Leak Repair in union city that stops the drip for good

When a metal roof starts leaking, every rainstorm turns into a countdown. Our Metal Roof Leak Repair in union city crews find the true source, seal it, and pressure-test the fix before we leave. We handle standing seam metal roof leak repair union city NJ homeowners and landlords call about most, from Bergenline Avenue walk-ups to West Street warehouses. Call (551) 348-9609.

Union City Roof Rescue serving union city, New Jersey
Careful work. Honest options.
About this service

What Metal Roof Leak Repair in union city actually involves

Metal Roof Leak Repair in union city is the process of locating and sealing water intrusion on metal roofing systems, including standing seam panels, exposed fasteners, ridge caps, and penetrations. Metal roofs fail differently than shingles. Fastener grommets dry out, panel seams open with thermal movement, and factory sealant at end laps cracks after years of freeze-thaw. We use a moisture meter and infrared thermal camera to trace where water enters, not just where the ceiling stain appears. Then we repair the actual failure point with the right sealant, flashing, or panel work.

Union City metal roofs take a beating. Hudson County humidity, salt air off the Hudson, and 100-degree summer panel expansion followed by January freezes all work against the seams. We see metal roofing repair union city, New Jersey jobs where a single failed pipe boot has been dripping into a bedroom ceiling for months. If you need metal roof leak repair near me union city, we can usually get eyes on the roof the same day. We also handle metal roof leak fixing union city calls for commercial buildings along Central Avenue and 32nd Street.

  • ✓ Same-day leak detection
  • ✓ Repairs, not replacements
  • ✓ Code-correct flashing work
  • ✓ Written warranty on the work
What's included

What our Metal Roof Leak Repair in union city includes

Every metal roof leak repair we do includes the full diagnostic and repair process, not just a quick sealant smear. Here is what is covered on a standard call. If your roof needs something beyond this scope, we will tell you upfront and price it separately before we start.

01
✓

Full leak diagnosis

Moisture meter and infrared thermal camera scan to find the actual entry point, not just the stain. We trace water from the roof surface to where it shows up inside.

02
✓

Failed fastener replacement

We pull backed-out or rusted fasteners and replace them with oversized gasketed screws that seal tight against the panel. This is the most common metal roof leak fix.

03
✓

Seam and penetration reseal

Panel seams, end laps, and every penetration get cleaned and resealed with Henry Company or Sika sealant rated for metal substrates and UV exposure.

04
✓

Flashing repair

Chimney, skylight, vent, and wall flashing details are inspected and repaired. We rebuild counterflashing where needed and install new ice and water shield at valleys.

05
✓

Water test and verification

Controlled water test over the repaired area followed by a moisture meter check inside. We confirm the fix works before we pack up and leave.

06
✓

Photo documentation and warranty

You get before and after photos of the repair plus written warranty paperwork emailed to you the same day. Everything documented for your records or insurance.

How it works

How our Metal Roof Leak Repair in union city works

We ask where the stain is, when it drips, and what kind of metal roof you have. That tells us whether to bring a moisture meter, infrared thermal camera, or both. We book a same-day or next-morning window and text you the tech's name before he arrives.

Our tech suits up in a safety harness, climbs the extension ladder, and walks the panels. He checks fasteners, seams, ridge caps, pipe boots, and every flashing detail. A roof inspection drone flies the high or steep sections we cannot safely walk. Expect 30 to 45 minutes on a typical union city home.

We show you photos of the failure point, explain what caused it, and give you a flat-rate price before any work starts. No hourly surprises. If the fix is a $250 reseal, we say so. If a panel section needs replacement, we say that too.

Most repairs take two to four hours. We remove failed sealant with a pry bar and utility knife, clean the substrate, apply new sealant with a caulking gun, and replace any damaged fasteners with gasketed screws. Larger panel work uses a pitch hoist to bring materials up safely.

Before we leave, we run a controlled water test over the repaired area and check inside with the moisture meter. If it is dry, we magnet-sweep the yard for dropped screws, haul away debris, and email you the warranty paperwork and before/after photos.

Metal Roof Leak Repair
STEP 01Phone triage

We ask where the stain is, when it drips, and what kind of metal roof you have. That tells us whether to bring a moisture meter, infrared thermal camera, or both. We book a same-day or next-morning window and text you the tech's name before he arrives.

Tools & methods

Tools and methods we use on metal roofs

01
✓

Infrared thermal camera

Finds wet insulation and hidden moisture behind ceilings and under metal panels without any destructive testing. This is how we locate leaks that do not show an obvious entry point on the roof surface.

02
✓

Moisture meter

Confirms saturation levels in decking, insulation, and drywall. We use it before and after the repair to verify the fix actually worked.

03
✓

Roof inspection drone

Flies steep pitches, tall commercial roofs, and hard-to-reach sections safely. Gives us high-resolution photos of every seam, fastener, and flashing detail.

04
✓

Pitch hoist

Safely brings panels, fasteners, and tools up steep metal roofs without damaging the roof surface or risking a fall.

05
✓

Caulking gun and sealant

Applies Henry Company and Sika sealants rated for metal substrates. We use the right product for each application, not a one-size-fits-all tube.

06
✓

Extension ladder and safety harness

OSHA-compliant access and fall protection on every job. No shortcuts on safety, ever.

Real results

Before and after.

Bergenline Avenue rowhouse pipe boot leak
Metal Roof Leak Repair

Bergenline Avenue rowhouse pipe boot leak

A homeowner on Bergenline Avenue had a growing ceiling stain in a second-floor bedroom. Two prior roofers had smeared sealant around the general area with no result. The leak dripped every time it rained more than 20 minutes.

After: We found a completely failed pipe boot that had cracked from UV exposure. Replaced it with a new silicone boot and resealed the penetration. Total repair time: 90 minutes. The ceiling stayed dry through the next three storms.

Book this service →
Central Avenue commercial standing seam leak
Metal Roof Leak Repair

Central Avenue commercial standing seam leak

A retail building on Central Avenue had water coming through the ceiling above the stockroom after every storm. The standing seam panels had multiple open seams from years of thermal movement, and factory sealant at the end laps was completely dried out.

After: We resealed 14 linear feet of open seam with polyurethane sealant rated for metal, replaced 22 failed fasteners with oversized gasketed screws, and reflashed two penetrations. Water test passed. No leaks through the following winter.

Book this service →
West Street chimney flashing failure
Metal Roof Leak Repair

West Street chimney flashing failure

A multi-unit building on West Street had water running down the inside of the chimney chase and staining the ceiling below. The counterflashing had pulled away from the masonry and water was running behind it into the roof deck.

After: We rebuilt the entire chimney flashing detail: new ice and water shield at the base, new step flashing, and new counterflashing cut into the masonry. Sealed with Sika polyurethane. The leak stopped immediately and the ceiling dried out within a week.

Book this service →
Problems we solve

Metal roof leak problems we fix in union city

Metal roofs fail in specific ways. Here are the problems we see most often on Union City buildings and how we solve them.

Ask a pro →
01

Ceiling water stains that keep growing after rain

We trace the stain back to the actual roof entry point using a moisture meter and infrared camera. Most ceiling stains on metal roofs trace to a failed pipe boot or an open panel seam. We fix the source, not the stain.

↗
02

Leaks around chimney and skylight flashing

We rebuild the flashing detail from the deck up. New ice and water shield at the base, new step flashing, new counterflashing cut into the masonry or curb. Sealed with Sika or Henry Company polyurethane rated for metal.

↗
03

Standing seam panels leaking at the seams

We clean the seam, apply new butyl or polyurethane sealant rated for metal, and mechanically close the seam where possible. For severe cases we install a standing seam metal roof leak repair union city NJ overlay strip sealed and fastened per manufacturer spec.

↗
04

Ice dams pushing water under panels in winter

We remove the ice dam safely without damaging the metal, then address the root cause with attic insulation improvements and heat cable installation. We also verify the ice and water shield at the eave is intact.

↗
Proof you can check

Licensed, insured, and warrantied

  • NJ Home Improvement Contractor (HIC) License · New Jersey Division of Consumer Affairs
  • OSHA Safety Certification · Occupational Safety and Health Administration
  • EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
  • NRCA Member · National Roofing Contractors Association
  • GAF Master Elite · GAF Materials Corporation
Customer reviews

What Union City customers say

★★★★★
“We had a ceiling stain growing for two months. Two other roofers told us we needed a full metal roof replacement. Union City Roof Rescue found a failed pipe boot in 20 minutes and fixed it for under $400. That was last fall and we have not had a drop since. Honest people.”
MG

Maria G.Homeowner, Bergenline Avenue

✓ Verified
★★★★★
“Called at 11 p.m. during a storm with water pouring into a tenant's unit. They had a tarp on the roof within two hours and came back the next morning to do the permanent standing seam metal roof leak repair. Professional, fast, and they cleaned up every screw. Highly recommend.”
PS

Priya S.Property Manager, Central Avenue

✓ Verified
Good questions

Frequently Asked Questions

(551) 348-9609

Most metal roof leak repairs in union city NJ run $275 to $1,200 in 2026, depending on access, roof height, and how many failure points we find. A simple pipe boot reseal might be $275. A full valley reflash with new ice and water shield can hit $1,200. We give you a flat-rate price before any work starts, so there are no surprises on the invoice.

We find the actual entry point using a moisture meter and infrared thermal camera, then repair the specific failure. That usually means resealing panel seams, replacing failed fasteners with gasketed screws, reflashing penetrations, or replacing a damaged panel section. After the repair we run a controlled water test and confirm the area is dry with the moisture meter before we pack up.

Yes, in most cases. Metal roofs are repairable, and full replacement is rarely needed for a leak. Failed fasteners, dried sealant, cracked pipe boots, and open seams are all fixable in place. We only recommend panel replacement when the metal itself is rusted through or storm-damaged beyond sealing. If you are searching standing seam metal roof leak repair union city NJ 07087, we can usually save the roof.

Union City Roof Rescue handles metal roof leak repair across union city and Hudson County, including West Street, Bergenline Avenue, Summit Avenue, and the North Bergen and West New York borders. We run same-day service and 24/7 emergency calls. Reach us at (551) 348-9609 and we will get a tech on your roof fast.

Ready when you are

Get your Metal Roof Leak Repair in union city scheduled today

Every day you wait, water is finding new paths through your ceiling and walls. Call Union City Roof Rescue at (551) 348-9609 for same-day metal roof leak repair. Licensed, insured, and warrantied. We answer 24/7 for emergencies.

Book My Repair (551) 348-9609 →
Request an appointment

Call Union City Roof Rescue

Call us at (551) 348-9609 or email info@unioncityroofrescue.com. We answer the phone 24/7 for active leaks and schedule standard inspections Monday through Friday. If you leave a message after hours, we call back within the hour.

↗
Emergency?Call now