Flat roof leaks sealed right the first time

Modified Bitumen Roof Leak Repair in union city

Modified Bitumen Roof Leak Repair in union city is what we do every week on the flat and low-slope roofs that cover so many buildings here. If water is staining your ceiling, pooling near a drain, or running down a wall after a storm, our crew finds the source and seals it. We work on homes, storefronts, and multi-family buildings across Hudson County, and we leave the roof watertight.

Modified Bitumen Roof Leak Repair
Careful work. Honest options.
About this service

What Modified Bitumen Roof Leak Repair in union city Involves

Modified Bitumen Roof Leak Repair in union city is the process of locating and sealing water intrusion on mod bit membrane roofs, which are asphalt-based sheets reinforced with fiberglass or polyester and installed in overlapping layers. The membrane is tough, but seams, flashing, and drain edges fail over time. We open the failed area, dry it, and re-lay new membrane or sealant so the repair bonds to sound material instead of trapping moisture underneath.

Union City's housing stock is dense and old, and most flat roofs here are modified bitumen or built-up roofing felt. Freeze-thaw cycles in January and February crack seams, then summer heat softens the asphalt and opens them further. If you have been searching for mod bit roof leak repair union city NJ, the leak is usually at a seam, a pipe boot, or where the membrane meets a wall or parapet.

  • ✓ Stop Ceiling Damage
  • ✓ Protect Insulation Value
  • ✓ Avoid Mold and Air Quality Issues
  • ✓ Extend Roof Life by Years
What's included

What Our Mod Bit Leak Repair Includes

Every modified bitumen roof leak repair includes a full inspection, diagnosis, repair, and water test. Here is what you get when you hire us.

01
✓

Full Roof Inspection

We walk the entire roof, not just the area above the leak. Leaks travel. A moisture meter and infrared camera help us find all the wet areas so we fix the whole problem, not just the visible spot.

02
✓

Leak Source Diagnosis

We identify the actual entry point and the cause. Was it a failed seam, a cracked pipe boot, or flashing that pulled away from the wall? Knowing the cause prevents the same leak from coming back.

03
✓

Membrane Repair or Replacement

We cut back the failed membrane to sound material and install new modified bitumen. Seams are heat-welded or adhered per manufacturer spec. We use GAF, Owens Corning, or Carlisle SynTec materials depending on your existing roof.

04
✓

Flashing and Penetration Sealing

Pipe boots, vents, skylights, and wall flashing get re-sealed with new membrane and roof cement. These are the most common leak points on mod bit roofs, so we address them while we are up there.

05
✓

Water Test and Warranty

We run water over the repaired area and check inside before we leave. You get a written workmanship warranty and photos of the finished repair. If it leaks again within the warranty period, we come back at no charge.

How it works

How Our Mod Bit Leak Repair Works

You call (551) 348-9609 or book online. We ask a few questions about where the water is showing up inside and how long it has been happening. Most Union City jobs get a same-day or next-day inspection slot, and emergency calls after a storm get priority.

A technician walks the roof with a moisture meter and, when needed, an infrared thermal camera to find wet insulation that is not visible from the surface. We check seams, flashing, pipe boots, drains, and the parapet walls. The inspection takes 30 to 60 minutes and you get a written summary.

We tell you exactly where the water is entering, what caused it, and what it takes to fix it. You get a clear price before any work starts. If the leak is at a seam and a patch will hold, we say so. If the membrane is at the end of its life, we tell you that too.

We cut back the failed membrane, dry the substrate, and install new modified bitumen or compatible sealant. Seams get heat-welded or adhered per the manufacturer's spec. Flashing and pipe boots get re-sealed with roof cement and new membrane. Most repairs take two to four hours.

Before we leave, we run water over the repaired area and watch for any sign of movement. We check inside the building if you are home. Then we clean up every scrap of old membrane and sealant. You get a written warranty on the repair and photos of the finished work.

Modified Bitumen Roof Leak Repair
STEP 01Call and Schedule

You call (551) 348-9609 or book online. We ask a few questions about where the water is showing up inside and how long it has been happening. Most Union City jobs get a same-day or next-day inspection slot, and emergency calls after a storm get priority.

Tools & methods

Tools and Methods We Use

01
✓

Moisture Meter

Detects moisture under the membrane surface. We use it to map the wet area and confirm the repair area is dry before sealing.

02
✓

Infrared Thermal Camera

Finds wet insulation that is not visible from the surface. Essential for large roofs where the leak source is far from the interior stain.

03
✓

Roof Inspection Drone

Surveys large or steep roof areas safely. We use it to document conditions and identify problem areas before sending a technician up.

04
✓

Pitch Hoist

Lifts heavy membrane rolls and materials to the roof without damaging the building or risking injury.

05
✓

Roofing Nail Gun

Fastens base sheets and insulation boards securely. We use it where mechanically attached systems are part of the repair.

06
✓

Caulking Gun

Applies sealant at flashing edges, pipe boots, and terminations. Proper application is critical for a watertight seal.

Real results

Before and after.

Seam Leak on Bergenline Avenue Storefront
Modified Bitumen Roof Leak Repair

Seam Leak on Bergenline Avenue Storefront

A storefront on Bergenline Avenue had water dripping onto the sales floor every time it rained. The previous roofer had patched the ceiling inside but never fixed the roof. The leak was at a seam near the parapet wall where the membrane had pulled away.

After: We cut back the failed seam, dried the substrate, and installed new modified bitumen with a heat-welded seam. Water test confirmed no leaks. The storeowner repaired the ceiling and has had no issues through two rainy seasons.

Book this service →
Pipe Boot Failure in Union City Heights
Modified Bitumen Roof Leak Repair

Pipe Boot Failure in Union City Heights

A homeowner in Union City Heights had a ceiling stain that kept growing. The leak was at a pipe boot that had cracked after years of UV exposure. Water was running down the pipe and into the ceiling below.

After: We replaced the failed pipe boot with a new one sealed to the membrane. The repair took about two hours. The homeowner repaired the drywall and the stain has not returned.

Book this service →
Ponding Water Repair on Summit Avenue Commercial Roof
Modified Bitumen Roof Leak Repair

Ponding Water Repair on Summit Avenue Commercial Roof

A commercial building on Summit Avenue had ponding water near a drain that was causing leaks into a tenant space. The drain was partially clogged and the roof pitch had settled over time.

After: We repaired the membrane around the drain, cleared the clog, and added a tapered section to improve drainage. The ponding stopped and the tenant space stayed dry through the next storm season.

Book this service →
Problems we solve

Common Mod Bit Leak Problems We Fix

These are the leaks we see most often on Union City modified bitumen roofs. If any of these sound familiar, call us.

Ask a pro →
01

Active leak during rainstorms

We find the entry point with a moisture meter and infrared camera, then seal it with new membrane and flashing. Emergency service available for active leaks.

↗
02

Ceiling water stains that keep spreading

We trace the stain back to the roof entry point, repair the membrane, and water-test to confirm the fix. You can then repair the interior damage with confidence.

↗
03

Ponding water near drains

We repair the leak, then check drain function and slope. If the drain is clogged or the pitch is off, we recommend a fix to prevent future ponding.

↗
04

Failed pipe boots and vent seals

We replace failed pipe boots with new ones sealed to the membrane. Vent bases get re-sealed with roof cement and new membrane.

↗
Proof you can check

Licensed, Insured, and Warrantied

  • NJ Home Improvement Contractor (HIC) License · New Jersey Division of Consumer Affairs
  • EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
  • GAF Master Elite · GAF
  • Owens Corning Preferred Contractor · Owens Corning
  • NRCA Member · National Roofing Contractors Association
Customer reviews

What Union City Customers Say

★★★★★
“Water was dripping into my kitchen every time it rained. Union City Roof Rescue found the leak at a seam near the parapet wall. They patched it and water-tested it before they left. That was six months ago and no leaks since. Fair price, showed up on time.”
MG

Maria G.Homeowner, Downtown Union City

✓ Verified
★★★★★
“Our storefront roof leaked right over the register. They came out same day, patched the leak, and came back the next week to do a permanent repair. No disruption to business. I have already recommended them to two other owners on the block.”
AP

Anthony P.Business Owner, Summit Avenue

✓ Verified
Good questions

Frequently Asked Questions

(551) 348-9609

Most modified bitumen roof leak repairs in Union City run $350 to $1,200 in 2026, depending on the size of the repair and whether insulation needs replacing. A simple seam patch is on the low end. A larger section with wet insulation and new flashing runs higher. We give you a fixed price before we start, so there are no surprises.

We find the entry point with a moisture meter and infrared camera, cut back the failed membrane, dry the substrate, and install new modified bitumen or compatible sealant. Seams are heat-welded or adhered to manufacturer spec. Then we water-test the repair and check inside. Most repairs take two to four hours from start to finish.

Yes, if the membrane around the leak is still sound. A patch works well for isolated seam failures, pipe boot leaks, and small flashing issues. If the membrane is brittle across a large area or has multiple leaks, patching is a temporary fix and we will tell you that upfront. We never patch a roof that needs replacement just to make a sale.

Union City Roof Rescue handles mod bit flat roof leak repair for homes, storefronts, and commercial buildings across Union City and Hudson County. We are licensed, insured, and EPA Lead-Safe Certified. Call (551) 348-9609 and we will schedule an inspection, usually same-day or next-day. Emergency calls get priority.

Ready when you are

Get Your Modified Bitumen Roof Leak Repair in union city

Water coming in now? Call (551) 348-9609 and we will get a truck to your address. We are licensed, insured, and we warranty every repair. Same-day inspections available.

Book Inspection (551) 348-9609 →
Request an appointment

Call Union City Roof Rescue

Call us at (551) 348-9609 or email info@unioncityroofrescue.com. We answer the phone 24/7 for active leaks and schedule standard inspections Monday through Friday. If you leave a message after hours, we call back within the hour.

↗
Emergency?Call now